BOMBARDIER 1982 Shop Manual page 233

c
• 'E
INSTALLATION
Lock crankshaft in position as explained in removal proce-
dure. Make sure crankshaft is rotated 45° counterlock-
wise from T.D.C. position and that cylinder is completely
filled with a starter rope.
CDI
Lubricate lightly pulley shaft with drive pulley lubri-
cant PIN 413800 700.
®
Pack inside of pulley shaft with drive pulley lubricant
PIN 413800 700.
Drive pulley
lubricant
SECTION 03 TRANSMISSION
SUB-SECTION 03 (DRIVE PULLEY)
®
Install governor cup correctly as per illustration making
sure that the rollers are sliding on their ramp .
Position the cap screw then lube and torque to 61 N.m
(45 ft -Ibs) .
•
WARNING: Shim(s)
CD
is(are) used to obtain a neu-
tral function of the drive pulley when engine is idling.
Proceed as follows when retaining bolt is torqued:
With a new drive belt installed, you should be able to in-
sert a minimum of 0.80 mm 1.030") thick feeler gauge on
each side of the drive belt simultaneously when pushing
drive belt to sit on bearing.
0.80 mm
feeler
gauge
feeler
gauge
Shim
CD
located between governor cup and drive pulley
shaft will help you to obtain correct adjustment. Use not
more then two (2) shims .
PAGE 231