BOMBARDIER 1982 Shop Manual page 252

SECTION 03 TRANSMISSION
SUB-SECTION 04 (DRIVEN PULLEY)
DRIVEN PULLEY REMOVAL
Remove the following items:
- Upper elastic stop nut retaining the front side pan
bracket.
- Two rear side pan retaining nuts.
- Belt guard and drive belt.
_ CAUTION: Always apply anti-seize compound on
..". the countershaft before final pulley installation
(Loctite anti-seize lubricant PIN 413701000).
Pull out the side pan and remove pulley assembly.
DISASSEMBLY AND ASSEMBLY
•
WARNING: The driven pulley cam is spring load-
ed. Hold in place when removing the circlip.
Check sliding halt bushing wear, replace bushing if wear
is excessive.
PAGE 250
To replace bushing, push out using a press.
Install new bushing using same procedure.
Check tension using a fish scale positioned at 90° with
the pulley axle.
To adjust spring tension, displace spring end
according~
Iy.
Reassemble by reversing removal procedure.