BOMBARDIER 1982 Shop Manual page 348

I
SECTION 05 SUSPENSION
SUB-SECTION 01 (BOGIE WHEELS)
REMOVAL
Raise and block rear of vehicle off the ground.
Release track tension by unlocking the link plate springs
using an appropriate tool.
Starting at center bogie wheel set, remove bolts and
lock washers securing cross shaft to frame.
O NOTE: To prevent the cross shaft from rotating
within the cross support, wedge a screwdriver blade
between the cross shaft and cross support.
Cross support
Remove bogie wheel set.
O
NOTE:
Since spring diameter may vary depending
upon actual installation location, it is important to
identify the installation of each bogie wheel set. Observe
this position when reinstalling sets.
Repeat operation for remaining bogie wheel sets .
PAGE 348
DISASSEMBLY
&
ASSEMBLY
CD
Heat wheel support anchor before attempting to open
or close anchor.
®
Clean, then lubricate cross shaft with low temperature
grease before installation.
®
Always pull or push bearing by inner race. When in -
stalling bearing on wheel support, position bearing shield
towards inner flange, then press down until bearing is sit-
ting flush with support end.
G)@
Bogie wheels are factory riveted. When separa-
tion is necessary, remove rivets securing wheel tire and
flanges by using a
3/16"
dia . drill. Secure flanges and
tire using bolts and nuts tighten in the following se-
quence to 38 N-m (28 ft-Ibs) .
6
5
Torque sequence