BOMBARDIER 1982 Shop Manual page 312

_ _ _ _ _ -:r
SECTION 04 ELECTRICAL
SUB-SECTION 02 (IGNITION TIMING)
Bring engine to 6000 R.P.M. for a brief instant.
Check timing mark alignment. If flywheel mark aligns
within housing marks, timing is correct.
Stop engine.
'r--I!fl~~ ___ - -
Housing marks
\
If flywheel mark did not align within magneto housing
marks, armature plate must be adjusted.
Armature plate will have to be moved to advance or
retard timing.
PAGE312
----
Timing too advanced, - - - -
turn armature plate
clock wise
To adjust remove rewing starter assembly and starter
pulley .
Using a 4 mm Allen key, loosen the two armature plate
retaining screws and lightly move plate in appropriate
direction. (Refer to the difference between timing marks
to determine how much to move the armature plate) .
Tighten the armature plate screws.
_ CAUTION: Make sure armature plate screws are
.". well secu red.
Reassemble starter pulley and assembly.
Recheck engine timing (make sure engine is cold).
Reinstall inspection plug.
/