BOMBARDIER 1982 Shop Manual page 424

SECTION 07 HOOD/FRAME
SUB-SECTION 01 (HOOD)
Nordik, Futura, Everest, Blizzard 5500 MX,
Blizzard 9500, Sonic MX, Ultra Sonic
Peel off protective film from w indshield.
Position windsh ield on the hood then push down until
tabs are fu lly inserted into hood slots.
Lock windshield tabs in position using the "0" rings.
Properly seat the windshield in place.
Using windshield holes as a guide, dril15 mm dia .
(3/ 16")
holes through the hood.
_ CAUTION: Ensure the electrical wires are pro-
Y
tected inside the hood.
Clean the hood.
If applicable, install the darts.
Install the windshield fixtures.
Torque to 3-5 N.m
(2-3 ft-Ibs)
(
r
Snap cap
Screw
"3.'k""ia;'
Cap retainer
Wi,d, hi,1d - -
e
7IZ?(
I
?,7ZZZ;+---
Hood
was~ ~~
Elastic stop
nut
If applicable, install the windshield trim .
If applicable, drill a 5 mm
(3/ 16")
hole in the windshield
to install the two windshield trim retaining tie wraps .
Locate tie wrap head inside the windshield.
(TYPICAL)
Drill 5 mm
3116"
Bmml","" 1
~
PAGE 424
Alpine
Peel off protective film from the new windshield.
Position windshield on hood then push until tabs are ful-
ly inserted into slots. Lock windshield tabs in position
using the eleven
(11)
"0" rings (install two (2) "0" rings
on outer tabs).
If applicable, install the windshield trim .
Elite
Align the windshield in position (in order to have the
windshield deflector pleat on each side in line with the
body side).
Mark the body, and drill
17/ 64"
holes. Secure the wind-
shield in place using the windshield fixtures.
_ CAUTION: Ensure the electrical wires are pra-
y
tected inside the hood.
If applicable, install windshield trim on outer edge, and
secure both ends by installing the two (2) tie wraps.
Install the trunk door stopper in place by drilling a
1/ 8"
hole in the center of the windshield at exactly 23 cm (9")
from bottom edge of windshield and push the trunk
door stopper in place.