BOMBARDIER 1982 Shop Manual page 376

SECTION 05 SUSPENSION
SUB-SECTION 04 (DRIVE AXLE)
The bearing on the splined side of axle must be pushed
until it is seated on bearing stop . The end bearing housing
bearing must be flush with end of drive axle. Each bearing
must have its shield facing the sprocket.
r - - - -
Bearing shield on this side - - - - . . . . ,
Flush with
drive axle
Seated on
bearing stop
@If the drive axle to be installed is a new component,
and the vehicle is equipped with a speedometer, a cor-
rect size speedometer drive insert must be installed into
the axle end . Ensure that insert is flush with end of axle.
PAGE 376
INSTALLATION
If the drive axle to be installed is a new component and
the vehicle is equipped with a speedometer, a speedome-
ter drive insert must be installed into the axle end. Ensure
that insert is flush with end of axle.
Position drive axle assembly into location. Install shim(s)
between bearing and lower chaincase sprocket . Install
end bearing housing .
Install chaincase and position seals, making sure that a
gap of approximately 2 mm
(1/16")
exists between end
of bearing housing and each seal.
Lock drive axle sprocket with a new cotter pin (Elan/
Spirit models) or circlip (other single track models).
Reinstall the chaincase cover.
Refill with chaincase oil.
Install the suspension. Apply track tension and carry out
track alignment procedure.