BOMBARDIER 1982 Shop Manual page 155

ASSEMBLY
@@To install bearing, use a press to push bearing in
mounting flange.
@At gear assembly, apply a light coat of grease on gear
teeth.
®
@
@Always check for spring clip and clamp tight-
ness .
ADJUSTMENT
_ CAUTION: The carburetors must be adjusted be-
. . fore adjusting the oil injection pump. Make sure
the idle speed is 1800-2000 R.P.M.
To synchronize pump with carburetor:
Eliminate the throttle cable free-play by pressing the
throttle lever until a light resistance is felt, then hold in
place. The aligning marks on the pump casting and on
the lever must align. If not, loosen the adjuster nut and
adjust accordingly.
Tighten the adjuster nut.
(TYPICAU
Outlet lines
Adjustment
nuts
_ CAUTION: Proper oil injection pump adjustment
. . is very important. Any delay in the opening of the
pump can result in serious engine damage.
SECTION 02 ENGINE
SUB-SECTION 06 (503 ENGINE TYPE)
To bleed oil lines:
IMPORTANT: Make sure all oil lines are full. If required,
bleed the inlet line and the pump by loosening the
bleeder screw. To bleed the outlet lines, hold the pump
lever in a fully open position with the engine at idle
speed until the air is bleed off .
+
WARNING: Perform this operation in a well venti-
lated area.
PAGE 153