BOMBARDIER 1982 Shop Manual page 340

SECTION 04 ELECTRICAL
SUB-SECTION 07 (TESTING PROCEDURE)
4-4P ignition type engine (354, 454, 464)
(Vehicle wiring)
Breakerless
magneto
(Test wire harness) A
Control unit
Ignition coil
~=-=- To D
To C
To E
4-5P ignition type engine (277, 377, 503)
(Vehicle wiring)
Breakerless
magneto
PAGE 340
Ignition coil
Control unit
(Test wire harness) B
O
NOTE: The harness
©
supplied in the kit is only
applicable to the Can-Am 504 engine type. For com-
plete 504 engine type testing procedure, refer to the ap-
propriate Can -Am Shop Manual.
TEST
a) Turn the power switch on. Then one LED or two
LEOs will light to indicate the checker is operating .
Reset the indication circuit by depressing the reset
switch, but then one LED remains to indicate the
checker is operati ng.
O
NOTE: After every test where in the LED level in-
dicator holds its indication a few minutes, reset the
indication circuit by depressing the reset switch.
b) Set the selector to the desired position .
c) Perform each test.
O
NOTE: When cranking the manual starter type en -
gine, perform it repeatedly.
d) If the test results are over or lower than the limit, see
"Analysis of test".
O NOTE: Test results should be repeated two or
three times. If reading does not repeat, output is
erratic and cause should be investigated . (Loose con-
nection of components, etc.).