BOMBARDIER 1982 Shop Manual page 241

•
• i
E
@ @ @
To install or remove "Duralon" bushing from
hub plug, use suitable pusher and hammer or press. In-
stall bushing as per illustration.
"Duralon" bushing
Apply "Loctite 242" on threads, then tighten until screw
slightly rests against bottom of "Duralon" bushing hole.
_ CAUTION: Be careful when installing outer half
... assembly on square shaft of drive pulley to avoid
scratches on "Duralon" bushing caused by square shaft
edge.
@
Torque to 5 N-m (4 ft-Ibsl.
@ @
At reassembly, apply "Loctite 242" on threads
and torque to 16 N-m (12 ft-Ibsl.
_ CAUTION: Do not disassemble counterweights un-
... less replacement is necessary.
@ @ @
Rollers and nylon washers must move freely;
install them as per illustration.
SECTION 03 TRANSMISSION
SUB-SECTION 03 (DRIVE PULLEY)
INSPECTION & CLEANING
Drive pulley should be inspected annually.
Check general condition of pulley and inspect "Duralon"
bushing faces, as per illustrations.
Teflon
impregnated
cloth
GOOD
GOOD
Teflon
: ......... "r!it-tt-
impregnated
cloth
Teflon
:4~."
impregnated
cloth
WORN (must be changed)
or torn and
fiberglass backing
is visible
Inside of outer half should be cleaned with a clean cloth .
The square shaft can be cleaned with fine steel wool
and a clean cloth.
PAGE 239