BOMBARDIER 1982 Shop Manual page 24

,
r
SECTION 02 ENGINE
SUB-SECTION 01 (247 ENGINE TYPE)
REMOVAL FROM VEHICLE
Remove or disconnect the following then lift engine
from vehicle.
- Pulley guard.
- Drive belt.
- Muffler.
- Choke knob.
- Decompressor.
- Throttle cable.
- Fuel lines .
- Electrical connector.
- Separate steering column support at upper column.
- Engine mount nuts .
ENGINE SUPPORT AND MUFFLER
DISASSEMBLY & ASSEMBLY
®
Torque to 31 N-m (23 ft-Ibs) .
@Torque to 35 N-m (26 ft-Ibs).
@Torque to 22 N.m (16 ft-Ibs).
.
INSTALLATION ON VEHICLE
To install engine on vehicle, inverse removal procedure.
However, pay attention to the following .
• Check tightness of engine mount nuts, @ and drive
pulley bolt.
• After throttle cable installation, check maximum
throttle slide opening.
• Check pulley alignment and drive belt tension.
PAGE24
11