BOMBARDIER 1982 Shop Manual page 375

ASSEMBLY
O NOTE: 1982 models have two different axle-sprocket
press fits. Ensure to replace ring reinforced sprockets
with the same type .
®To assemble press fit sprockets, use a press and a
pipe (1
1/8
1.0.) as illustrated. Sprockets must be as-
sembled with the following dimensions.
A - ...... .,.1 ..... -
B
On Citation and Mirage models:
Dimension A
=
100 mm (3
15/16")
Dimension B
=
225.5 mm (87/8")
On Everest, Futura (Futura
300
excepted), Blizzard
5500
MX, Sonic, Blizzard 9500 and Ultra Sonic models:
Dimension A
=
104.5 mm (47/64")
Dimension B
=
242 mm
(917/32")
Ensure to align indexing marks on each sprocket before
assembling the second sprocket.
The maximum synchronization tolerance for the sprock-
ets is 1.5
mm
(1/16").
To check this tolerance, place axle assembly on a plane
surface and measure the gap between sprocket teeth
and surface.
Even surface
SECTION 05 SUSPENSION
SUB-SECTION 04 (DRIVE AXLE)
_ CAUTION: The same sprocket must not be pressed
" twice on the axle. If synchronization is found to be
defective, use a new sprocket.
o
NOTE: Idler wheel
G)
must turn freely .
@ @ @
®
Tightening torque for axle flanges is 3-4 N-m
(2-3 ft-Ibs).
When reassembling, install a new nut or apply "Loctite"
(or equivalent) on old threads . Tighten in the following
sequence.
G)When assembling drive axle, always position a new
seal on each end of drive axle. The _ seal lip must face
sprocket as illustrated.
®@Always push bearing by inner race.
PAGE 375