BOMBARDIER 1982 Shop Manual page 33

Ie
.0 ® ®
Whenever a coil is replaced, the air gap (dis-
tance between magnet and coil end) must be adjusted.
To check air gap, insert a feeler gauge of 0.25-0 .38 mm
L010"-.015") between magnet and coil ends. If neces-
sary to adjust, slacken retaining screws and relocate coil.
Checking air gap
ASSEMBLY
- Clean crankshaft extension (taper).
- Apply Loctite 242 (blue, medium strength!.
- Position magneto on crankshaft with the keyway and
the cam notch indexed as illustrated:
Centrifugal weight
operation
- @@ Rotate breaker cam to check centrifugal weight
operation.
- @ At assembly, apply a small amount of grease into
spring seating.
- @@
At assembly, apply "Loctite 242" on screw
threads .
- @ At assembly, thoroughly clean threads and apply
"Loctite 242", then torque retaining nut to 85 N·m
(63 ft-Ibs).
SECTION 02 ENGINE
SUB-SECTION 01 (247 ENGINE TYPE)
- ®
@At rea ssembly coat all electric connections with
dielectric or lithium grease to prevent corrosion or
moisture from penetrating.
_ CAUTION : Do not use silicone sealant, this pra-
y
duct will corrade contacts.
PAGE 33
J