BOMBARDIER 1982 Shop Manual page 229

c
o
Install governor cup correctly as per illustration mak-
ing sure that the rollers are sliding on their ramp.
Position the cap screw then lube torque to 61 N.m (45
ft-Ibs) .
SECTION 03 TRANSMISSION
SUB-SECTION 03 (DRIVE PULLEY)
•
WARNING: Shim(s)
@
is(are) used to obtain a
neutral fonction of the drive pulley when engine is
idling. Proceed as follows when retaining bolt is torqued:
With a new drive belt installed, you should be able to insert
a minimum of 0.80 mm (,030") thick feeler gauge on each
side of the drive belt simultaneously when pushing drive
belt to sit on bearing.
0.80
mm
feeler gauge
0.80
mm
Shim
@
located between governor cup and drive pulley
shaft will help you to obtain correct adjustment. Use not
more than two (2) shims.
PAGE 227