BOMBARDIER 1982 Shop Manual page 100

SECTION 02 ENGINE
SUB-SECTION 05 (464 ENGINE TYPE)
REMOVAL FROM VEHICLE
Disconnect or remove the following from vehicle:
- Pulley guard and drive belt
- Air silencer and throttle cable
- Fuel lines, primer, pulsation and oil injection lines
- Muffler and rewind starter
- Electric wires
•
WARNING: Always disconnect ground cable first,
before any other wire of the starting system.
- Drain the cooling system and disconnect hoses at en-
gine
- Rotary valve oil reservoir
- Disconnect rewind starter at engine
ENGINE SUPPORT AND MUFFLER
DISASSEMBLY AND ASSEMBLY
®Torque to 36 N.m (26 ft-Ibs).
@Torque to 22 N.m (16 ft-Ibs) .
INSTALLATION ON VEHICLE
To install engine on vehicle, reverse removal procedure.
However, pay attention to the following:
• Check tightness of engine mount nuts
• After throttle cable installation, check carburetor maxi-
mum throttle slide opening and oil pump adjustment
• Check pulley alignment and drive belt tf;lnsion
PAGE 98