BOMBARDIER 1982 Shop Manual page 207

c
To adjust rope tension:
Wind rope on sheave and place rope sheave into starter
housing making sure that the sheave hub notch en-
gages in the spring hook.
Rotate the sheave counterclockwise until rope end is
accessible through starter housing orifice.
Pull the rope out of the starter housing and temporarily
make a knot to hold it.
1 turn preload will give
7 turns of tension when fully extended
®
@@Position pawl, pawl lock and circlip .
@ Install lock spring and lubricate with Molybdenum
base grease.
Install lock ring.
SECTION 02 ENGINE
SUB-SECTION 11 (REWIND STARTER)
INSTALLATION
On oil injection models, reinstall oil pump on rewind
starter assembly.
Reinstall rewind starter assembly on engine.
O NOTE: If applicable, connect hood retaining cable
to rewind starter retainer bolt.
Prior to installing starter grip on new rope, it is first ne-
cessary to fuse the rope end with a lit match. Pass rope
through starter grip, and tie a knot in the rope end. Fuse
the knot with a lit match then turn the knot down and
pull the starter grip over the knot.
PAGE 205