BOMBARDIER 1982 Shop Manual page 374

SECTION 05 SUSPENSION
SUB-SECTION 04 (DRIVE AXLE)
1. Drive axle
2. Spacer tube
3. Idler
4. Spacer tube
5. Sprocket
6. Circlip
7. Seal
8. Bearing
9. Bearing
10.. Speedo drive insert
11. Retainer ring
12.
End bearing housing
13. Lockwasher
5/ 16
REMOVAL
Drain oil from chaincase or gear box . Release drive chain
tension (if applicable) .
Raise and block rear of vehicle off ground .
Remove suspension .
Pry oil seals from chaincase and end bearing housing .
Remove end bearing housing and unlock drive axle
sprocket (single track models) .
O
NOTE: If applicable, remove battery and its seat.
If vehicle is equipped with a speedometer, remove
angle drive unit and coupling cable.
Release drive sprock'et teeth from track notches, at the
same time, pulling the drive axle towards the end bear-
ing housing side of frame.
Remove drive axle from vehicle . If applicable , pullout
shim located between bearing and lower chaincase
sprocket .
DISA SSEMBL Y
@Remove speedo drive insert (if applicable).
G),®To
remove bearings, use puller assembly, ring and
half rings as illustrated. (Refer to tools section)
PAGE 374
14.
Hexagonal head cap screw
1/4-20.
x
3/4
15. Shim
16. Sprocket 34 teeth
17 Hexagonal head cap screw 1/4-20. x 1
18. Hexagonal elastic stop nut 1/4-20.
19. Bushing
20.
Hexagonal flanged elastic stop nut
1/4-20.
21. Grease fitting
22. Mobile flange
23. Cable protector
24.
Flat washer
17/64
x
7/8
x
.0.60.
25. Rubber spacer
26. Hexagonal flanged elastic stop nut 1/4-20.
®When replacing sprockets, make a reference mark on
the axle to facilitate reassembly of the new sprockets .
To remove, press fit sprockets (drive axle without
flange) , use a press and a suitable support as illustrated .
I
I
Support sprocket near hub
I