BOMBARDIER 1982 Shop Manual page 380

SECTION 05 SUSPENSION
SUB-SECTION 05 (TRACK)
To correct alignment, loosen link plate spring lock nut
on side where track is closest to the link plate.
Turn track adjuster bolt on same side, clockwise until
track re-aligns.
Tighten link plate spring lock nut .
Alignment (slide suspension all models)
With rear of vehicle supported off the ground, start engine
and allow the track to rotate slowly.
Check that track is well centered and turns evenly. To
correct, stop engine then loosen the lock nuts and
tighten the adjuster bolt on side where guides are closest
to slide. Tighten lock nuts and recheck alignment.
(TYPICAL)
•
WARNING: Before checking track alignment, en-
sure that the track is free of all particles which
could be thrown out while track is rotating. Keep hands,
tools, feet and clothing clear of track.
TRACK INSERT INSTALLATION
Using N°. 529004500 tool (with two standard
jigs)
("Moto-Ski" jig PIN 529004 300)
Tilt vehicle on its side to expose the track notches then
place insert into position .
PAGE 380
Place the track insert installer into track notches and
position male jig on top of track insert.
Tighten installer bolt until track insert is locked in place .
_ CAUTION: To prevent damages and for an easier
. . operation of the tool, apply grease on male jig,
female jig and to the installer bolt threads.
Femalejig
Using N°. 529002600 tool
For narrow
;ooort'~
.(
For wide inserts
Place inserts into position and, with tool being under
the inserts, tap them over the track using a hammer.
Q t==\
IFJDt==\
!==-c::=
J
9t
------------>A~~----
Tool - - - - - - - - - - -