BOMBARDIER 1982 Shop Manual page 50

,...--------
SECTION 02 ENGINE
SUB-SECTION 02 (277 ENGINE TYPE)
7. Injection oil tank
2. Support
3. Grommet
4. Male connector
5. Gasket
6. Oil tank cap
7. Retainer rod
8. External tooth lockwasher
1/ 4
9. Hexagonal washer head taptite screw M6 x 30
10. Retaining washer
77. Hexagonal elastic stop nut
72. Oil line 7.5" (38 mm)
73. Oil line 5" 027 mm)
74. Spring clip (3)
75. Spring clip
76. Filter
77. Oil pump mounting flange
78. Oil pump
79. Washer 6.2 (2)
20. Oil pump gear 27 teeth
27. Lock nut 6 mm
22. Locwasher 5(2)
23. Cylindrical slotted screw M5 x 76 (2)
24. Ball bearing
25. Gear 9 teeth
26. Oil banjo gasket (2)
27. Banjo
28. Banjo bolt
29. Oil line 380 mm 05")
30. Clamp (4)
37. Taptite screw M5 x 20 (4)
32. O'ring (4)
33. Plate
34. Screw with lock washer
35. Retainer
36. O 'ring
37. Cam casing plate
38. Washer
39. Hexagonal head cap screw M6 x 7
40. Spring
47. Washer
42. Lever
43. Lockwasher 6
44. Hexagonal nut 6 mm
45. Seal
46. Gasket set
47. Oil
Parts in illustration marked with' are not available as
spare parts.
PAGE 50
CLEANING
Clean all metal components in a non-ferrous metal clean-
er.
DISASSEMBLY
O
NOTE: Some oil pump components are not avail-
able as spare parts .
@
@
To remove retaining nut. lock gear in place using
no. 420 876 690 too l.
PI N 420 876690
Gear holder
@ @To remove bearing. heat@mounting flange to ap-
proximately 175°-200°C (350°-400° F) using a propane
torch. Then strike cover on hard flat surface and bearing
will fall out .
•
WARNING: Always wear protective gloves, to avoid
burns while handling cover.
ASSEMBLY
@@To install bearing. use a press to push bearing in
mounting flange.
@At gear assembly. apply a light coat of grease on gear
teeth .
@@Always check for spring clip and clamp tightness.
J)-