BOMBARDIER 1982 Shop Manual page 423

c
c
c
HEADLAMP BEAM AIMING
Place the vehicle on a flat surface 7.6 m (25') from a wall
or screen.
TOP VIEW
Headlamp horizontal
center line Wall
Lmmu~
7.6 m (25 tt)
SIDE VIEW
Ground
With the suspension correctly adjusted, the rider seated
on the vehicle and the high beam ON (engine must be
running on manual start models), check that the center
of the high intensity zone of the high beam is 50 mm
(2") below the horizontal line of the headlamp height.
Headlamp
horizontal
center line
Center line
of intensity zone
I ntensity zone
Of high beam
(projected on the wall)
50 mm
To adjust, on vehicles so equipped remove the headlamp
chrome ring, turn the upper or lower adjusting screws to
obtain the desired beam position.
BULB REPLACEMENT
If headlamp is burnt, tilt cab, unplug the connector from
the headlamp. Remove the rubber boot and unfasten the
bulb retainer clips. Detach the bulb and replace. If the
tailling bulb is burnt. expose the bulb by removing red
plastic lens. To remove, unscrews the two (2) Phillips
head screws. Verify all lights after replacement.
- r T - - - - - - - - - . , . . , -
SECTION 07 HOOD/FRAME
SUB-SECTION 01 (HOOD)
HOOD MAINTENANCE
Clean the vehicle thoroughly, removing all dirt and grease
accumulation.
_ CAUTION: Plastic alloy components such as fuel
. . tank, windshield, hood, etc. can be cleaned using
mild detergents or isopropyl alcohol. Do not use strong
soaps, degreasing solvents, abrasive cleaners, paint
thinners, etc.
Inspect hood and repair damage. Repair kits are available
at your authorized dealer.
O
NOTE: Apply wax on glossy finish of hood only.
Protect the vehicle with a cover to prevent dust
accumulation during storage .
_ CAUTION: If for some reason the snowmobile has
." to be stored outside it is necessary to cover it with
an opaque tarpaulin. This caution will prevent the sun
rays affecting the plastic components and the vehicle
finish.
DECAL
To remove a decal, pull it off.
Clean the surface.
Apply liquid soap on the new decal. Position the decal
and pass a sponge over it to remove air bubbles and
water. Allow to air dry.
WINDSHIELD INSTALLATION
Elan, Spirit, Citation, Mirage, Skandic
Pel I off the protective film from the windshield.
Position the windshield on the hood then push it down
until the tabs are fully inserted into the hood slots. Lock
the windshield tabs in position using the "0" rings.
Elan models: do not install "0" rings on second and
seventh tabs.
If applicable, install the windshield trim.
PAGE 423