Driven Pulley; Gearbox Oil Level - BOMBARDIER Alpine 1987 Operator's Manual

To grease the inner side bogie wheels,
tilt vehicle on its side and apply pressure
on track to expose grease fittings.
Rear axle
Lubricate the rear axles with low-tem-
perature grease. Pump grease through
the rear axle fittings using a low-pres-
sure grease gun.
..
$
A017005006
Gearbox oil level
The gearbox oil capacity is 455 ml ( 16
oz). To check level:
Remove rubber inspection cover lo-
cated on bottom right side of gearbox.
Using a rigid piece of wire as dipstick,
check oil level. Oil level must reach 82
mm (3
1/4")
on dipstick.
A017003030
/I
A~
I[W
~-
To fill, remove filler cap from top of
gearbox. Refill as required using Bom-
bardier chaincase oil (P/N 413 8019 00
200 ml).
Driven pulley
Remove pulley guard and slip off drive
belt. Open the driven pulley, (push and
twist sliding half.)
Thoroughly clean the driven pulley
shaft.
Apply a light film of low-temperature
grease on the shaft. Always wipe off
surplus.
0
NOTE: Activate the sliding half
several times to distribute lubri-
cant over full length of shaft. Be care-
ful that lubricant does not get on inner
halves of pulley.
______________________ 21