BOMBARDIER 1982 Shop Manual page 210

I
SECTION 03 TRANSMISSION
SUB-SECTION 01 (PULLEY GUARD)
REMOVAL
Pullout hair pin and remove driven pulley guard. Pull on
spring to disengage pin from frame bracket, in order to
disengage drive pulley guard.
+
WARNING: Engine should be running only when
pulley guard is well secured in place.
(3)
The length of uncompressed pin spring should not be
less than 47 mm (1
7/ 8")
@An uncompressed front guard spring should not be
less than 20 mm
(13/ 16").
When assembling adjust
length to 17 mm
(11 / 16").
----= .-
17
mm
INSPECTION
® ®
Check condition of coil pin . Replace any damaged
parts .
INSTALLATION
Prior to installation, ensure that pulley guard and frame
bracket are 90° with frame.
No free-play
+
WARNING: No lateral free-play should exist be-
tween drive pulley guard and frame bracket.
Slide pulley guard into bracket.
Pull on lower spring bolt, engage pin into frame bracket
and install hair pin.
Install driven pulley guard.
PAGE 208
- - - - - -