BOMBARDIER 1982 Shop Manual page 218

SECTION 03 TRANSMISSION
SUB-SECTION 02 (DRIVE BELT)
ROTATION DIRECTION
The maximum drive belt life span is obtained when the
belt has the proper rotation direction.
CORRECT
Identification
STANDING FACE TO PULLEYS
INCORRECT
t
Identification
STANDING FACE TO PULLEYS
O
NOTE: For used drive belt, mark and reinstall in
the same rotation direction.
REMOVAL & INSTALLATION
_ CAUTION: Do not force or use tools to pry the belt
" . into place, as this could cut or break the cords in
the belt .
...... WARNING: Do not operate snowmobile without
.... drive belt or its guard installed. Serious bodily in-
jury could occur.
Tilt cab and remove pulley or belt guard.
PAGE216
• For Citation, Mirage, Nordik, Futura 300 and Skan-
dic models, to remove belt from pulleys and vehicle.
Loosen the countershaft bearing retaining screw
and open the bearing cage.
Open the driven pulley by twisting and pushing the
sliding half. Hold in fully open position.
Slip the belt over the top edge of the sliding half .