Page 3
To validate limited warranty coverage, low CR combustion chamber in- serts must be installed on engine at predelivery before using the vehicle. The high CR combustion chamber inserts must have been returned to BOMBARDIER Warranty Department. CONTROLS/INSTRUMENTS 45 25-26 32 30...
9) Tether Cut-Out Switch Attach tether cord to clothing then snap tether cut-out cap over re- ceptacle before starting engine. To stop engine, completely pull cap from safety switch. 45) Primer Button Pull and push button. It is not necessary when engine is warm. To prime, activate button until a pumping resistance is felt.
Page 5
➁ BOMBARDIER FORMULA XP-S synthetic injection oil and BOM- BARDIER injection oil are compatible, they can be mixed together. BOMBARDIER injection oil is a special blend of basic oil and additives especially selected to ensure unequalled lubrication, engine cleanliness and minimum spark plug fouling.
Page 6
OIL/FUEL 33/1 A32I09A METRIC (SI) 1 L of oil + 33 L of fuel = 33/1 IMPERIAL 35 imp. oz of oil + 7.2 imp. gal of fuel = 33/1 1 L of oil + 7.2 imp. gal of fuel = 33/1 UNITED STATES 34 U.S.
STARTING PROCEDURE • Re-check throttle control lever operation. • Ensure that the emergency cut-out switch is in the ON position. • Ensure the tether cut-out cap is in position and that the cord is attached to your clothing. • To prime, activate button until a pumping resistance is felt. From this point, pump 2 or 3 times to inject fuel in intake manifold.
MAINTENANCE Track Tension and Alignment Loosen lock nut on both adjustment screws before adjusting track tension and/or alignment. Retighten after adjustments are done. A32F0WA LEFT SIDE SHOWN 1. Lock nut on adjustment screw...
Need help?
Do you have a question about the ski-doo MX Z X 440 2001 and is the answer not in the manual?
Questions and answers