BOMBARDIER 1982 Shop Manual page 237

• I'
(3)
Torque to 7 N·m (5 ft-Ibs) .
(]) Apply "Loctite 242" on threads then screw in until
head is flush with hub plug . Do not allow head to bite
into hub plug .
® ®
@)
At disassembly, hold hub plug firmly against
outer half until the two (2) bolts are completely removed.
This will prevent damage of the outer half threads. At
assembly, apply "Loctite 242" on threads of bolts then tor-
que to 16 N.m (12 ft-Ibs).
@
Apply" Loctite 271" or equivalent on threads then
torque the screws to 14 N.m (10 ft-Ibs) or tighten with
an impact screwdriver.
@To install or remove "Duralon" bushing from hub
plug, use suitable pusher and hammer or press. Install
bushing as per illustration.
Insert bushing
widest portion
in first
_ CAUTION: Be careful when installing outer half
. . assembly on square shaft of drive pulley to avoid
scratches on "Duralon" bushing caused by square shaft
edge.
@
®
Install shouldered pin bushing as shown.
Bushing
Bushing location
Hub plug
®
@
Apply" Loctite 242" on threads and torque to 14
N.m (10 ft-lbsL
_ CAUTION: Do not disassemble counterweights un-
. . less replacement is necessary.
SECTION 03 TRANSMISSION
SUB-SECTION 03 (DRIVE PULLEY)
INSPECTION & CLEANING
Drive pulley should be inspected annually.
Check general condition of pulley and inspect "Duralon':
bushing faces, as per illustrations.
GOOD
Teflon coating
GOOD
Teflon
:..... ....
~~I-
impregnated
cloth
Teflon
.....
p..II~+
impregnated
cloth
WORN (must be changed)
Teflon
impregnated
&..1"-0"
cloth
or torn and
fiberglass backing
is visible
Inside of outer half should be cleaned with a clean cloth.
The square shaft can be cleaned with fine steel wool
and a clean cloth.
PAGE 235