Chrysler 160 Workshop Manual page 314

I
CHANGING THE REAR BRAKE SHOES
2
Fig . 4
• Remove worn brak e shoes with t heir antl-noi se
springs.
- Replace spring pins (Fig. 4).
4428
- Fit new brake s ho es in position (Fig.
5).
Locate
each shoe in position in l ower yoke groove,
compress anti-noise spri ng, then engage shoe in
up per groove.
- Push each pf s ton to bottom of hyd rau 1 i c
cylinders. To achieve this, sc rew pis ton In,
using tool Ref. 21645 V (Fig. 6) .
Fig. 5
44:29
The pis ton groove must be facing side of bleed
screw, and m ust be parallel with the arms of the
hydraulic cylinder. Thi s requi r emen t r. : us t be
met
if subsequent com pl ete bleed ing is to
be
ach
i
cverl,
Engage one side of ca ll ip er be twe ~n spri ng r in
and key area.
- E ngage other s i de of callip er i n pos iti on ,
compr essing both spri ng pins .
-Engage l ower key ret' : l ining call i pe r to yoke in
posi tf on.
Ftg. 6
4430
CHRYSLER
160-160GT·180
Reprint or translation, even partial, is strictly proh ibited without written permission from CHRYSLER FRANCE