Advertisement
AQ;E:
RE ·ASSEMBLING THE ENGINE
12
Fig. 33
. Fit and lock adjuster (Fig.
(5) (Fig. 29).
3907
33) plugging screw
. Use mallet to fit both cylinder head front cover
locating bushes, and use grease to fit both
gaskets to cylinder block.
- Fasten front cover, and tighten It to torque,
using
both
bushes to locate It in position.
~FITTING
THE OIL PUMP ASSEMBLY
. Use mallet to fit both pump locating bushes on
lower }oint plane.
. Bring oil pu11p assembly, fitted with Its driving
chain, tnto position, and fit it Into place on
Fig.
34
3908
Fig. 35
3909
crankshaft pinion (Fig. 34).
. Place pump In position on cylinder block, making
use of Its locations to set it correctly •
- Manually check chain tension.
- Insert an additional spacer between cylinder
block and pump supports to verify w hether an
additional spacer would cause chain tension to
be excessive (Fig. 35).
Note: Chain tension •ust not be excessive •
Spacers have a thickness of .05 and .1 ••·
. Fasten pump to cylinder head, and tighten
it
to
torque by uans of tts 2 THM 8 x 1.25-80 screws
(Fig. 36).
Fig. 36
3910
CHRYSLER
160-160GT-180
Reprint or translation,
even
partial, is strictly prohibited without wrillen permission from CHRYSLER FRANCE
Advertisement
