Chrysler 160 Workshop Manual page 224

I
OVERHAUL OF DIFFERENTIAL
8
Fig. 26
- Fill space between 2 1 Irs of seal wi t h Shell
Alvan ia EP 2 or Ret in ax A grense.
4102
- Place finnl differential flange in posi tion on
differen tial pinion end, then push it on the
grooves, using tool Ref. 21644 U, whi ch is to be
screwed onto differenti al pinion (F!g. 26).
- Remove thi s tool when it becomes harder to sc r 8' . 1 1
on, and finis h flange fl tting operation wit h a
new nylstop nut and the flat washer. Ti ghten
to 25 to 30m daN final torc;ue (Fig. 27). Use
Lauravl a S 108. 20 torque wrench , Lauravi a
C 1C8 .40 ex tension, and Lauravia C
E'5
S end-
piece. Se t torque wrench sll ding- gauge to
ha lf the prescribed torque value.
Fig. 27
4103
Fig. 28
3.
Adjustment of differential taper
bearing pre-load a nd bevel gear
tooth play
4104
T his adjustment is acbi eved by mod ifying t he shape
of both diff er en tial bearing caps ,
It must be ca rr! ed out whenever a new di ffer ent! al
bearing is fl tted.
If the initial bear ings are retai ned, the ori ginal
adjustment must be retained as the pre-load, If
necessary, t ooth pl ay can be adjusted wl thout
deforming th e bea rings.
Fig. 29
4105
CHRYSLER
160- 160 GT- 180
Reprint or translation , even partial, is strictly prohibited wit hout written permission from CHRYSLER FRANCE