Chrysler 160 Workshop Manual page 228

F6;x
REMOVING AND RE-FITTING A WHER SHAFT
Fig. 1
4112
160 .MClDEL
REMOVAL FROCEDURE
- Unlock rear wheel.
- Set rear of vehicle on pins, then remove wheel
after marking its position.
- Remove brake drum.
- Remove 4 screws fastening brake anchor plate to
ban
j
o ( F i g • 1 ) •
- Re;ove wheel shaft whilst holding brake anchor
plate to avoid damaging the brake tube, which
has not been disconnected (Fig. 2).
Fig . 3
M
-
~
Fig. 2
4113
Use a Facom U 41 Inertia extractor fitted w i th a
plate to be m ade by the operator to the
dimensions shown on Fig. 3.
- Once wheel shaft is removed, hold brake anchor
plate to banjo trumpet tube by m eans of 2 ~c rews.
RE-FITTING OPERATIONS
- Fit a new pap er seal on brak e ancho r pl at e.
- Insert w heel shaft in trum pet tube, then remo ve
both screws us ed to hold the brake anchor plate.
G.041
54 54
t
£114
145
CHRYSLER
160- 160 GT- 180
R.print or lranalalion, even partial, is strictly prohibited without written permiuion from CHRYSLER FRANCE