Chrysler 160 Workshop Manual page 147

REMOVING AND RE-FITTING THE ClUTCH
PlATE AND MECHANISM
F1nz:
Fig. 1 4023
REMOVAL ffiOCEDURE
- Remove gear box.
- Fit starti ng motor
crowr-whe ~ l
rotation loc king
tool lr ')os ition (Fig. 1).
- Remove screws fastening mechanism to fly wheel,
loosening them gradually.
- R emove cl utch mechanism and plate,
Fig. 2
4024
1
Fig. 3 4025
RE-FITTING O¥£RATIONS
- Fit plate (hub offset to•ards
rea~)
and mechanism
in position.
Note: Balancing R ef. marks (paint marks) must
f~ce
one another (Fig . 2) . Taking fixing points
into consideration, these marks may be offset by
• 0
a maximum of -
60 •
- Locate plate in position with pi lot tool
Ref. 21620 Y (Fig. 3).
- h'ith m echanism fitted on Mecanindus pins,
progressively tighten screws.
- Remove starting motor crown-wheel locking tool.
R e-fit gear box.
[ ·-·Reprint or tron$lotion,
~ven
partial, is strictly proh ibited without written permission from CHRYSLER FRAN CE
CHRYSLER
1 bO - 1 bO G T - 180