Chrysler 160 Workshop Manual page 213

REMOVING AND RE- FITIING
THE DIFFERENTIAL
F6;v
3
Fig. 8 4065
- Remove brake discs.
- Remove 4 screws fastening each brake deflector
to banjo (Fig. 9).
- Remove wheel shafts (Fig. 10), us!n9 a FaCOin U 41
Inertia extractor fitted with a plate to be made
by the operator
to
the dimensions shown on Fig. 7,
- Remove brake deflectors.
Fig. 9
4066
Fig. 10
4067
The following operations are common to
160 - 160 GT and 180 models
- D! sconnect 2 brake tubes from banjo three-way
connection.
- Remove these 2 brake tubes.
- Ex
tract fastener retai nl ng 3-way connection, <r1d
leave connection attached to flexible pfpe.
- Place an hydraulic jack bearing against
differential housing (Fig. 11).
Fig. 11
4068
Reprint or translation, even partial, is strictly prohibited without written perminion from CHRYSLER FRANCE
CHRYSLER
160-160GT-180