Advertisement
REMOVING AND RE-FITTING A STEERING RACK BELLOWS
6
Fig. 14
3965
- Remove steering rack.
- Remove knuckle, and lock-nut on king pin side
(Fig. H).
- Remove •orn bello•s (Fig. 15).
- Drain steering rack.
- Wrap adhesfve tape around threaded end of steering
drag rod, to avoid damaging new bellows when
fitting same In position.
Fig. 15
3966
-Fill steering rack body, w hich will
be
placed
vertically, with a quantity of oil equivalent to
150
cm
3 , through the opening cleared
by
the
bellows.
- Fit new bellows In position,
and
fasten It, fitting
the coll ars (Fig. 16) in the correct eli recti anal
setting.
- Re-f! t knuckle and lock-nut.
- Re-fl t steering rack.
-Adjust toe-ln.
CHRYSLER
160- 160 CiT- 180
Reprint or translation, even partial,
Is
strictly prohibited without written permission from CHRYSLER FRANCE
Advertisement
