Chrysler 160 Workshop Manual page 243

REMOVING AND RE-FITTING A STUB AXLE
Fig. 26
4250
R~OVAL
ffiOCEDURE
- Fro:n inside, use a tar>ered punch or a bpering
ri ece of wo0d to plug compensating
tan~
lo111er hole
(Fig.
1).
- Remove 3 nuts fas tening upper section of
susrensi on unit to fP.nder flange (Fig,
19).
- Unlock front .,neel.
- Set fr ont of vehi r le Cln pins, then remove wheel
aft er marking its pos ition.
Fig. 27
4261
7
Fig. 28
4262
-Disconnect brake tube from flexible pipe (Fig. 26).
- Extract flexible pipe retaining fastener.
.. Unlock, and remove the screws fasten ing the yoke
tr
the stub axle.
- Rerr.ovc the brake yoke, 111i thout disconnecting f
t'Jbe f rom the yoke (Fig. 27).
- Remove hub cap, using tool Ref.
4025 K
(Fig.
- Remove hub nut, t hP.n remove hub and disc as
assembled (Fig. 29).
Fig.29
426..l
Reprint or tran•lation, even partial, i• drictly prohibited without written permiuion from CHRYSLER FRANCE
CHRYSLER
160-160GT-180