Chrysler 160 Workshop Manual page 271

Fig. 8
REMOVING THE TUBE
- Remo ve steering w heel.
- Remu ve combined switc h.
- Loosen screw fastenin g col l ar to lower shell.
- Clear m at from toe board.
- Renove screws fastening l ower shell to toe
boa rd.
- S 1 i de 1 o
111
e r s h ell u
r
a 1 on g tube ( F i g. 7) •
- Punc h m ark th e rel ative position between
cardan joint and up r er steering shaft.
Fig . 9
3961
3962
Fig. 10
3963
- Remove screw fa steni ng cardan joint to upp er
s t eer i ng shaft.
- Remove both screws fas{ening the steeri ng column
tu be supporting bracket to the dash panel, and
r em ave tube.
~-t~OVING
THE UPPER STEERING SHAFT
(from removed tube)
- T urn ignition key to ignition position.
- Extract upp er fl exible ring, using the steering
shaft as an extractor (Fig. 8).
- R em ove upper steeri ng shaft.
H.H:MOVTh'G THE LOWill FLEXIBLE H.ING
(From r emoved tube)
U nc l inch lower fl exi ble rin g (two tabs folded
down to an angle of app roxim ately 30° ) (Fig, 9).
- Ex t ract lower flexi ble ring, using th e steering
shaft as an extrac t or (F ig. 10).
R&print or tranalation, even partial, Ia alrictly prohibited without written perrn.iuion from CHRYSLER FIANCE
CHRYSLER
160-160GT-180