Manually Adding Flags To The Cs_Module_Parameters Tab - Polycom RealPresence 1500 Administrator's Manual

Manually Added, Modified, Deleted System Flags
Flag
VSW_RATE_TOLERANCE_
PERECENT
VSW_SD_HP_THRESHOLD_
BITRATE
WRONG_NUMBER_DIAL_
RETRIES

Manually Adding Flags to the CS_MODULE_PARAMETERS Tab

Using the procedure to manually add flags to the System Configuration, the following flags can be manually
added to the CS_MODULE_PARAMETERS tab:
Manually Added CS_MODULE_PARAMETERS System Flags
Flag
CS_ENABLE_EPC
H245_TUNNELING
H323_RAS_IPV6
H323_TIMERS_SET_
INDEX
Polycom®, Inc.
Description
Determines the percentage of bandwidth that can be deducted from the
required bandwidth to allow participants to connect to the conference.
For example, a value of 20 will allow a participant to connect to the
conference if the allocated line rate is up to 20% lower than the conference
line rate (or between 80% to 100% of the required bandwidth).
Range: 0 - 75
Default: 0
Controls the Minimum Threshold Line Rate (kbps) for SD resolution for
High Profile-enabled VSW conferences.
Default: 128
The number of re-dial attempts for a wrong destination number or a wrong
destination number time-out.
Range: 0 - 5
Default: 3
A flag value of 0 means that no redials are attempted.
Description
Add this flag with the value YES (default value is NO) to enable endpoints that support
People+Content and require a different signaling (for example, FX endpoints) to receive
Content.
For use in the Avaya Environment.
In the Avaya Environment, set the flag to YES to ensure that H.245 is tunneled through
H.225. Both H.245 and H.225 will use the same signaling port.
Default: NO.
If the Collaboration Server is configured for IPv4 & IPv6 addressing, RAS (Registration,
Admission, and Status) messages are sent in both IPv4 and IPv6 format. If the
gatekeeper cannot operate in IPv6 addressing mode, registration fails and endpoints
cannot connect using the Collaboration Server prefix.
In such cases this System Flag should be set to NO.
Default: YES
Enables or disables H.323 index timer according to standard or proprietary H.323
protocol.
Possible values:
0 (Default) - Sets the H.323 index timer to Polycom proprietary.
1 - Sets the H.323 index timer based on the H.323 Standard recommendation.
Note: For homologation and certification testing, this flag must be set to 1.
System Configuration Flags
793