Configuring The Collaboration Server; Configuring Dma; Configuring Cma - Polycom RealPresence 1500 Administrator's Manual

The following Polycom peripheral:
• Polycom Touch Control
SIP ONLY (no TIP support)
Spectralink wireless phones 8020/8030
Polycom VVX 1500
Polycom VVX 1500 C
KIRK Wireless Server 300/600v3/6000
The following procedures 1 -16 are a summary of the configuration procedures.
The detailed procedures 1 - 16 begin with
System Flag.

Configuring the Collaboration Server

1 Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag
2 Configuring the Collaboration Server to statically route outbound SIP calls to DMA or CUCM
3 Configuring the Collaboration Server's H.323 Network Service to register with CMA gatekeeper
4 Configuring a TIP enabled Profile on the Collaboration Server
5 Configuring an Ad Hoc Entry Queue on the Collaboration Server if DMA is not used
6 Configuring a Meeting Room on the Collaboration Server
7 Configuring Participant Properties for dial out calls

Configuring DMA

If DMA is present in the configuration perform procedures
Configuring a Virtual Meeting Room
calls to Collaboration Server.
1 Configuring DMA to route SIP calls to CUCM
2 Configuring a Virtual Meeting Room (VMR)
The procedures for configuring DMA are described in detail in the Polycom Unified Communications
Deployment Guide for Cisco Environments.
.

Configuring CMA

1 Configuring CMA to route H.323 calls to Collaboration Server
2 Configuring CMA for use with Cisco IOS Gatekeeper (Neighbored)
3 Configuring CMA to route H.323 calls to CUCM
4 Configuring CMA to route non-H.323 calls to CUCM
The procedures for configuring CMA are described in detail in the Polycom Unified Communications
Deployment Guide for Cisco Environments.
.
Polycom®, Inc.
Appendix I - Polycom Open Collaboration Network (POCN)
Procedure 1: Set the MIN_TIP_COMPATIBILITY_LINE_RATE
Configuring DMA to route SIP calls to CUCM
(VMR), otherwise skip to procedure
1.3.0
Version(s)
V4.0
V3.3.1
Configuring CMA to route H.323
and
1051