Polycom RealPresence 1500 Administrator's Manual page 817

Manually Added, Modified, Deleted System Flags
Flag
RFC2833_DTMF
RMX_MANAGEMENT_SECURITY_
PROTOCOL
RTCP_FIR_ENABLE
RTCP_FLOW_CONTROL_TMMBR
_ENABLE
RTCP_FLOW_CONTROL_TMMBR
_INTERVAL
RTCP_PLI_ENABLE
RTCP_QOS_IS_EQUAL_TO_RTP
RTV_MAX_BIT_RATE_FOR_
FORCE_CIF_PARTICIPANT
SELF_IND_LOCATION
Polycom®, Inc.
Description
Controls the receipt of in-band and out-of-band DTMF Codes. When set to:
• YES The RMX will receive DTMF Codes sent in-band.
• NO The RMX receive DTMF Codes sent out-of-band.
The RMX always sends DTMF Codes in-band (as part of the Audio Media
stream).
Range: YES/NO
Default YES
Enter the protocol to be used for secure communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
When set to YES, the Full Intra Request (FIR) is sent as INFO (and not
RTCP).
Default = YES
Enables/disables the SIP RTCP flow control parameter.
Default: YES
Modifies the interval (in seconds) of the TMMBR (Temporary Maximum
Media Stream Bit Rate) parameter for SIP RTCP flow control.
Range: 5 - 999 (seconds)
Default: 180
When set to YES, the (Picture Loss Indication (PLI) is sent as INFO (and
not RTCP).
Default = YES
Range: YES/NO
Default: YES
Enables the removal of empty video cells from a Video Layout.
Change the location of the display of the Network Quality Indicator of the
participant's own endpoint.
Default: BOTTOM_RIGHT
Range:
• TOP_ LEFT
• TOP
• TOP_RIGHT
• BOTTOM_ LEFT
• BOTTOM
• BOTTOM_RIGHT
NOTE: This flag's function has been replaced by the Network Quality check
box in the Layout Indications tab of the New Profile / Profile Properties
dialog.
System Configuration Flags
787