Polycom RealPresence 1500 Administrator's Manual page 799

Manually Added, Modified, Deleted System Flags
Flag
ALLOW_NON_ENCRYPT_PARTY_
IN_ENCRYPT_CONF
ALWAYS_FORWARD_DTMF_IN_
GW_SESSION_TO_ISDN
(ISDN)
ANAT_IP_PROTOCOL
APACHE_KEEP_ALIVE_TIMEOUT
AVOID_VIDEO_LOOP_BACK_IN_
CASCADE
BLOCK_CONTENT_LEGACY_FOR
_LYNC
Polycom®, Inc.
Description
If YES, allows non-encrypted participants to connect to encrypted
conferences.
Default: No
Note: From Version 7.6.1, this flag is replaced by the Encryption option
"Encrypt when Possible" in the conference Profile - Advanced dialog box.
Flag setting is ignored.
Applicable to the RealPresence Collaboration Server
(RMX) 1500/2000/4000 only.
When set to YES, all DTMF codes sent by participants in the GW session
will be forwarded to all PSTN and ISDN participants in the same GW
session.
Range: YES / NO
Default Value: NO
If YES, enables Alternative Network Address Types. For more information,
see Alternative Network Address Types
Range: DISABLED, AUTO, PREFER_IPv4, PREFER_IPv6
Default:
• ULTRA SECURE MODE: NO
• STANDARD SECURITY MODE: YES
If the connection is idle for longer than the number of seconds specified by
this flag, the connection to the Collaboration Server is terminated.
Value: 0 - 999
Default: 15
Default (ULTRA_SECURE_MODE=YES): 15
Note: A value of 0 results in an unlimited keep-alive duration. This value
should never be used in Ultra Secure Mode.
When set to YES the current speaker's image is not sent back through the
participant link in cascaded conferences with conference layouts other than
1x1.
Default: YES
Range: YES / NO
This flag is used to control the system behavior in an environment where
some Lync clients use the Polycom CCS plug-in and some do not.
When set to NO (default), Content is sent to all Lync clients over the video
channel, including those with the plug-in installed, even when the Send
Content to Legacy Endpoints is disabled. Other, non-Lync legacy endpoints
will not be affected by this flag and will receive content according to the
Send Content to Legacy Endpoints settings in the conference Profile.
When set to YES, Content is not sent to Lync clients over the video channel
including those with the Polycom CCS plug-in installed, even when the
Send Content to Legacy Endpoints is enabled. Other, non-Lync legacy
endpoints will not be affected by this flag and will receive content according
to the Send Content to Legacy Endpoints settings in the conference Profile.
System Configuration Flags
(ANAT).
769