Manually Adding And Deleting System Flags - Polycom RealPresence 1500 Administrator's Manual

Manually Adding and Deleting System Flags

MCMS_PARAMETERS_USER Flags
Flag
ALLOW_NON_ENCRYPT_
PARTY_IN_ENCRYPT_CONF
ALLOW_NON_ENCRYPT_
RECORDING_LINK_IN_
ENCRYPT_CONF
AUTHENTICATE_USER
BONDING_CHANNEL_DELAY
(ISDN)
CHANGE_AD_HOC_CONF_
DURATION
CHECK_ARPING
Polycom®, Inc.
Description
If YES, allows non-encrypted participants to connect to encrypted
conferences.
Default: NO
Note: From Version 7.6.1, this flag is replaced by the Encryption option
Encrypt when Possible in the conference Profile - Advanced dialog box.
Flag setting is ignored.
When set to NO (default), the Recording Link inherits the encryption
settings of the conference. If the conference is encrypted, the recording link
will be encrypted.
When set to YES, it disables the encryption of the recording link,
regardless of the Encryption settings of the conference and RSS recorder.
This flag is not supported from Version 7.7.
If the external database application is to be used to verify that operators are
authorized to log in to the MCU, set the value of this flag to YES.
If the value of this flag is set to NO, the MCU database is used to verify that
operators are authorized to log in to the MCU.
Note: If the flag is set to YES, the flow is first to look in the internal DB and
then go out to the external one.
Flags for SE200 need to be added manually.
Applicable to the RealPresence Collaboration Server
(RMX) 1500/2000/4000 only.
When connecting a bonding group, this is the delay (number of 1/100
seconds) between dialing attempts to connect sequential channels.
The channel per second connection performance of ISDN switches can
vary and can cause timing issues that result in bonding channel
disconnection.
Default: 6
The duration of an ad-hoc conference* can be configured on a system level
by setting the flag to one of the following values (in minutes): 60 (default),
90, 180 and 270.
* An ad-hoc conference is automatically created when the participant dials
into an Ad-hoc Entry Queue and enters a conference ID that is not being
used by any other conferencing entity. It is based on the Conference Profile
assigned to the EQ.
This flag is not supported from Version 7.7.
Disables Duplicate Address Detection and should be configured according
to local site policy. When set to YES, Duplicate Address Detection is
enabled in for both IPv4 and IPv6. When set to NO, Duplicate Address
Detection is disabled for both IPv4 and IPv6. When using IPv6, ICMPv6
type 135 packets are also disabled.
System Configuration Flags
752