Enabling, Disabling And Modifying The White List - Polycom RealPresence 1500 Administrator's Manual

Collaboration server
Hide thumbs Also See for RealPresence 1500:
Table of Contents

Advertisement

● Changes to the White List are written to the Auditor Event File.
● Alterations to the White List do not require a system reset.

Enabling, Disabling and Modifying the White List

The use of White List in the environment can be enabled or disabled in the Management Network Service
- White List dialog box.
To enable, disable, view or modify the White List:
1 In the RMX Management pane, click the IP Network Services.
The IP Network Services pane is displayed.
2 In the IP Network Services list pane, double-click the Management Network entry.
The Management Network dialog box is displayed.
3 Click the WhiteList tab.
The WhiteList dialog box is displayed.
 If there are no entries in the White List, it is disabled to prevent lock out.
 If the White List is disabled none of the IP addresses in the list are displayed.
 The Add and Remove buttons are only active if the Enable Whitelist check box is selected.
4 Select the Enable Whitelist check box.
All IP addresses in the list are displayed and the Add and Remove buttons become active.
5 Modify the White List.
Both IPv4 and IPv6 addresses are supported and the system will only allow an entry of the type of
IP addresses for which the Management Network Service is configured according to the table
below.
Polycom®, Inc.
Ultra Secure Mode
851

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RealPresence 1500 and is the answer not in the manual?

This manual is also suitable for:

Realpresence 1800Realpresence 2000Realpresence 4000

Table of Contents