Using Hot Backup Triggers; Guidelines For Configuring The Hot Backup Triggers - Polycom RealPresence 1500 Administrator's Manual

Collaboration server

Hide thumbs Also See for RealPresence 1500:

Table of Contents

1 On the Collaboration Server menu, click Setup > Hot Backup.

The Hot Backup dialog box is displayed.

2 Complete or modify the following fields:

Hot Backup Enabled

Paired MCU IP Address

Synchronization Status

Using Hot Backup Triggers

Hot Backup is initiated by the slave MCU on detection of no response from the master MCU on a Keep Alive

operation. The Hot Backup triggers initiates the Hot Backup swap from Master to Slave when the selected

conditions on the Master MCU occur.

● Hot Backup triggers should be configured on both the Master and Slave MCUs.

Polycom®, Inc.

Select this check box to enable Hot Backup.

This setting determines the role of the MCU in the Hot Backup configuration.

Select either Master MCU or Slave MCU from the drop-down menu.

Enter the Control Unit IP Address of the:

Slave MCU (if this MCU is the Master)

Master MCU (if this MCU is the Slave)

The status of the synchronization between the Master and Slave MCUs in the

Hot Backup configuration is indicated as:

OK - Hot Backup is functioning normally, and the Master and Slave MCUs are

synchronized.

Attempting - Hot Backup is attempting to synchronize the Master and Slave

Fail - A failure occurred while trying to synchronize the paired MCUs.

None - Hot Backup has not been enabled.

Administration and Utilities

Table of Contents