Manually Adding Flags To The Cs_Module_Parameters Tab - Polycom RealPresence 800s Administrator's Manual

RealPresence Collaboration Server (RMX) 800s/Virtual Edition Administrator's Guide

Manually Adding Flags to the CS_MODULE_PARAMETERS Tab

Using the procedure to manually add flags to the System Configuration, the following flags can be manually
added to the CS_MODULE_PARAMETERS tab:
Manually Added CS_MODULE_PARAMETERS System Flags
Flag
CS_ENABLE_EPC
H245_TUNNELING
H323_TIMERS_SET_I
NDEX
MS_UPDATE_CONTAC
T_REMOVE
QOS_IP_SIGNALING
SIP_DUAL_DIRECTIO
N_TCP_CON
SIP_ST_ENFORCE_VA
L
Polycom®, Inc.
Description
Add this flag with the value YES (default value is NO) to enable endpoints that support
People+Content and require a different signaling (for example, FX endpoints) to receive
Content.
For use in the Avaya Environment.
In the Avaya Environment, set the flag to YES to ensure that H.245 is tunneled through
H.225. Both H.245 and H.225 will use the same signaling port.
Default: NO.
Enables or disables H.323 index timer according to standard or proprietary H.323
protocol.
Possible values:
0 (Default) - Sets the H.323 index timer to Polycom proprietary.
1 - Sets the H.323 index timer based on the H.323 Standard recommendation.
Note: For homologation and certification testing, this flag must be set to 1.
When the flag value is set to:
• YES - The Contact Header is removed from the UPDATE message that is sent
periodically to the endpoints.
This is required when the SIP Server Type field of the IP Network Service is set as
Microsoft. Removal of the Contact Header from the UPDATE message is required
specifically by OCS R2.
• NO - The Contact Header is included in the UPDATE message. This is the system
behavior when the SIP Server Type is set as Generic.
This is required when the Collaboration Server is configured to accept calls from both
Microsoft LYNC and Cisco CUCM as CUCM requires the Contact Header.
Used to select the priority of IP packets when DiffServ is the is the selected method for
packet priority encoding.
Range: 0x##
Default: 0x28
For use in Microsoft environments.
When set to YES, sends a new request on the same TCP connection instead of opening
a new connection.
Range: YES/NO
Default: NO
For use in Microsoft environments.
Session timer interval in seconds.
Default = YES
646