Table of Contents
Advertisement
Chapter 4: Repair information
Factory defaults
© Copyright IBM Corp. 2005
This chapter describes the repair and repair-related procedures for
the SAN32M-1 and associated field-replaceable units (FRUs). These
procedures are described:
•
Obtain log information.
•
Display and use EFC Server views.
•
Obtain and interpret port diagnostic and performance data, and
perform port diagnostic loopback tests.
•
Swap ports (FICON Management Style only).
•
Collect maintenance data.
•
Clean fiber-optic components.
•
Power the switch on and off.
•
Perform an initial program load (IPL).
•
Set the switch online or offline.
•
Block or unblock Fibre Channel ports.
•
Manage firmware versions.
•
Manage configuration data.
•
Install or upgrade software.
Do not perform repairs until a failure is isolated to a FRU. If fault
isolation was not performed, refer to
page 183.
Table 15
lists the defaults for the passwords, and IP, subnet, and
gateway addresses.
MAP 0000: Start MAP
on
291
Advertisement
Table of Contents
