Table of Contents
Advertisement
Rack-Mount installation
64
SAN32M-1 Installation and Service Manual
— Areas with excessive heat, dust, or moisture are avoided.
— All planning considerations are met. Refer to the IBM
TotalStorage Products in a SAN Environment Planning Manual.
3. Verify that all FRUs are installed as ordered.
4. Verify that the SFP optical transceivers are installed as required
for your installation.
5. Connect the U.S. or country-specific (optional) AC power cords to
the right (PS0) and left (PS1) receptacles at the rear of the chassis.
A supplied power cord is provided for each switch power
supply. To prevent electric shock when connecting the switch to
primary facility power, use only the supplied power cord(s),
and ensure the facility power receptacle is the correct type,
supplies the required voltage, and is properly grounded.
6. Connect the remaining ends of the AC power cords to separate
facility power sources that provide single-phase, 120 to 240 volts
alternating current (VAC) current. This provides power
redundancy.
7. Turn on the power. Two power switches are on the back of the
unit.The unit powers on and performs power-on self-tests
(POSTs). During POSTs:
a. The green power (PWR) LED on the front panel illuminates.
b. The amber system error (ERR) LED on the front panel blinks
momentarily while the switch is tested.
c. The green LEDs associated with the Ethernet port blink
momentarily while the port is tested.
d. The green and amber LEDs associated with the ports blink
momentarily while the ports are tested.
8. After successful POST completion, the green power (PWR) LED
remains illuminated and all other front panel LEDs extinguish.
9. If a POST error or other malfunction occurs, go to
MAP
on page -183 to isolate the problem.
To install the switch in a customer-supplied equipment rack, refer to
the Rack-Mount Kit Installation Instructions.
MAP 0000: Start
Advertisement
Table of Contents
