Table of Contents
Advertisement
Message
SNMP trap address not defined.
Description
An SNMP trap address must be defined if a community name is
defined.
Action
Define an SNMP address.
Message
Switch Binding was removed from attached devices that are also
participating in Port Binding. Please review the Port Binding
Configuration.
Description
The device WWNs were removed from the director's Switch
Membership List (SANtegrity Switch Binding feature), but you
should note that one or more of these devices still has security control
in port binding.
Action
Verify that the security level for each device is as required by
reviewing the Bound WWN list in the Configure Ports dialog box.
Message
Stop diagnostics failed. The test is already running.
Description
Diagnostics for the port was not running and the Stop was selected on
the Port Diagnostics dialog box. Diagnostics quit for the port for some
reason, but the Stop button remains enabled.
Action
Verify port operation. Retry diagnostics for port and select Stop from
the dialog box. If problem persists, contact your service
representative.
Message
Stop diagnostics failed. The test was not running.
Description
The action to stop diagnostics failed because the test was not running.
Action
Informational message.
Appendix A: Messages
399
Advertisement
Table of Contents
