Table of Contents
Advertisement
Configure Network Information
• McDATA Fabric 1.0 - Select this option if the product is
fabric-attached only to other IBM directors or switches
operating in McDATA fabric mode.
• Open Fabric 1.0 - Select this option (default) for managing
heterogeneous fabrics and if the product is fabric-attached
to IBM directors or switches and other open-fabric
compliant switches.
NOTE: With Open Fabric 1.0 enabled, the default zone set is disabled.
3. Click OK to save and activate changes.
4. Set the product online. Refer to
page 334 for instructions.
Verify the LAN installation with the network administrator. If:
•
One product is installed on a dedicated LAN, network
information (IP address, subnet mask, and gateway address) does
not require change.
•
Multiple products are installed or a public LAN segment is used,
network information must be changed to conform to the LAN
addressing scheme.
Perform this procedure to change product network information.
1. Select Switch and Network from the Configure menu at any view.
The Network View displays
Set the switch online or offline
(Figure
101).
Chapter 2: Installation tasks
on
163
Advertisement
Table of Contents
