Table of Contents
Advertisement
Configure fabric parameters
f. At the Zone Flexpars: Isolate Fabric RSCNs on zone activation
changes field, check (enable) or uncheck (disable) the
parameter. When enabled, zone FlexPars isolate and prevent
fabric-format RSCNs from propagating to devices in zones
that are not impacted.
g. At the Preferred Domain ID field, type a value between 1
through 31. This value uniquely identifies each fabric element.
NOTE: An ISL between fabric elements with identical domain IDs
segments and prevents communication.
h. At the ISL FSPF Cost Configuration field, select By Port Speed or
Ignore Port Speed to calculate fabric shortest path first (FSPF)
cost.
• By Port Speed - The fastest fabric path is determined by
port (ISL) speed. Cost is inversely proportional to speed.
• Ignore Port Speed - ISL speed is ignored, and the fastest
fabric path is determined by the number of hops. Cost is
directly proportional to hop count.
3. Click OK to save and activate changes.
4. Set the product online. Refer to
page 334 for instructions.
Perform this procedure to configure fabric operating parameters.
1. Set the product offline. Refer to
page 334 for instructions.
2. Select Switch and Fabric Parameters from the Configure menu at any
view. The Fabric Parameters View displays
Set the switch online or offline
Set the switch online or offline
(Figure
100).
Chapter 2: Installation tasks
on
on
161
Advertisement
Table of Contents
