Table of Contents
Advertisement
1. Ensure the switch is defined to the SAN management application
(defined while performing
management application
2. Ensure the preferred domain ID for the switch is unique and does
not conflict with the ID of another switch participating in the
fabric. To change the domain ID, refer to
SAN32M-1 Element Manager applications
3. Ensure the R_A_TOV and E_D_TOV values for the switch are
identical to the values for all switches participating in the fabric.
To change the values, refer to
Element Manager applications
4. Route a multimode or singlemode fiber-optic cable (depending
on the type of SFP transceiver installed) from a
customer-specified E_Port of the switch to the director.
5. Connect the switch-attached fiber-optic cable to the port SFP
transceiver.
6. If the switch is managed by an attached management server, go to
step
7. If the switch is managed by the EFCM Basic interface:
a. At the Configure panel, select View at the left side of the panel.
The View panel opens with the Unit page displayed.
b. At the View panel, click the Port Properties tab. The Port
Properties page displays with a port number selected
(highlighted red), and port information listed.
c. Ensure the Operational State field displays Online and the
Reason field displays N/A or is blank. If an ISL segmentation or
other problem is indicated, go to
page -183 to isolate the problem. If no problems are indicated,
installation tasks are complete.
7. At the management server's Product View, click the switch icon.
The Hardware View for the selected switch displays.
8. Click the port connector (leftmost port) to open the Port Properties
dialog box.
Task 13: Configure the switch to the
on page -101)
Task 19: Configure
on page -126.
Task 19: Configure SAN32M-1
on page -126.
MAP 0000: Start MAP
Chapter 2: Installation tasks
on
177
Advertisement
Table of Contents
