Table of Contents
Advertisement
Configure and enable Ethernet events
a. Type the IP address or DNS host name of the SMTP server in
the SMTP Server field. Use 64 alphanumeric characters or less.
It is recommended the IP address be used.
b. For the E-Mail Addresses fields, type the e-mail addresses of up
to five recipients who should be informed of system events.
Use 64 alphanumeric characters or less for each entry.
3. To enable e-mail transmission to configured addresses, click the
Enable E-Mail Event Notification check box. A check mark appears
in the box when transmission is enabled.
NOTE: The enable function must also be activated for each switch
through the Element Manager application. E-mail notification can be
active for some switches and inactive for others.
4. Click OK to save the information and close the dialog box.
5. Double-click the SAN32M-1 icon. The Hardware View for the
selected switch displays.
6. At the Hardware View, select Enable E-Mail Notification from the
Maintenance menu. A check mark appears in the check box to
indicate e-mail notification for the switch is enabled, and the
menu closes.
Perform this procedure to configure and enable Ethernet events. An
Ethernet event is recorded (after a user-specified time interval) when
the switch-to-management server communication link drops. To
configure and enable Ethernet events:
1. Close the Hardware View and return to the Products View by
clicking close (X) at the upper right corner of the window.
2. Select Configure Ethernet Events from the Maintenance menu. The
Configure Ethernet Events dialog box displays
(Figure
85).
Chapter 2: Installation tasks
143
Advertisement
Table of Contents
