Table of Contents
Advertisement
EFCM Basic interface
326
SAN32M-1 Installation and Service Manual
card, then transfers (through the Ethernet connection) the captured
dump file from FLASH memory to the EFC Server hard drive.
NOTE: An optional full-volatility feature is often required at military sites
that process classified data. If the feature is enabled through the switch's
maintenance port, a memory dump file (that possibly includes classified
Fibre Channel frames) is not included as part of the data collection procedure
Perform the maintenance data collection procedure after a firmware
fault is corrected or a failed FRU is replaced to capture the data for
analysis by support personnel. Maintenance data includes the dump
file, hardware log, audit log, and an engineering log viewable only by
support personnel.
To collect maintenance data (retrieve the dump file from the CTP
card) at the EFCM Basic interface:
1. When the EFCM Basic interface opens, the View panel and Switch
page appear as the default. At the View panel, select the Operations
option at the left side of the panel. The Operations panel opens
with the Switch page displayed.
2. Click the Maintenance and Dump Retrieval tabs. The Maintenance
page displays with the Dump Retrieval tab selected.
3. Right-click the CTP Dump link to open a list of menu options.
4. Select the Save Target As menu option. The Save As dialog box
displays
(Figure 177
on page 327).
Advertisement
Table of Contents
