Remove Engine Rear Oil Seal; Install Engine Rear Oil Seal; Install Drive Plate & Ring Gear Sub-Assy - Toyota 2002 Camry Service Manual

SST
SST
6
8
4
2002 CAMRY REPAIR MANUAL (RM881U)
ENGINE MECHANICAL
7.
(a)
(b)
HINT:
After the removal, check if the crankshaft is not damaged.
Cut Position
If there is, mend it with a sandpaper (#400).
A53052
8.
(a)
NOTICE:
Keep the lip off foreign materials.
(b)
NOTICE:
A32658
Wipe off extra grease on the crankshaft.
9.
(a)
A32665
(b)
(c)
(d)
SST
A62061
(e)
1
3
7
5
2
A61988
– ENGINE REAR OIL SEAL (2AZ–FE)

REMOVE ENGINE REAR OIL SEAL

Using a knife, cut off the oil seal lip.
Using a screwdriver with taping its tip, pry out the oil seal.

INSTALL ENGINE REAR OIL SEAL

Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its sur-
face is flush with the rear oil seal retainer edge.
SST 09223–15030, 09950–70010 (09951–07100)
INSTALL DRIVE PLATE & RING GEAR SUB–ASSY(A/T
TRANSAXLE)
Fix the crankshaft with SST (TMC made).
SST 09213–54015 (91651–60855), 09330–00021
Fix the crankshaft with SST (TMMK made).
SST 09960–10010 (09962–01000, 09963–01000)
Clean the bolt and the bolt hole.
Apply Adhesive to 2 or 3 threads of the bolt end.
Adhesive :
Part No. 08833–00070, THREE BOND or equivalent
Install and uniformly tighten the 8 bolts, in several passes,
in the sequence shown.
Torque: 98 N m (1,000 kgf cm, 72 ft lbf)
Author :
14–105
Date :
1629